Parameter Presets

 
A Parameter Preset stores a set of fixed parameter values for later recall. The parameters which can be included in the preset must first of all exist within a Parameter Preset Group. When a preset is stored, it is the values of the parameters within its group which are stored for later recall.

Parameter Presets can be recalled manually from the drop down list in the Presets toolbar or by using the logic Preset Trigger or logic Preset Table. Alternatively, drag the parameter preset button from the Design Tree and drop it onto a control port or a custom control panel to recall the preset. Parameter presets can also be used as part of a Device or Venue Preset

To add a Parameter Preset to a Parameter Preset Group, press the "Add Parameter Preset" button on the Preset Toolbar. Give the preset a name (relating to its function) and it will then appear in the drop down list of Parameter Presets (second drop down box).

To assign values to the selected parameters, use the quick Operate mode (hold down the Alt key in a control panel) and adjust the controls to the required values. Now, let go of the Alt key (as the settings cannot be stored in Operate mode). These values can now be saved using the "Store Parameter Preset" button from the Preset toolbar.

Once presets are assigned they appear in the Design Tree under the Presets folder. The presets are shown within their Parameter Preset Group.

To check the values stored within a Parameter Preset use the Stored Parameter Value Editor found on the Preset toolbar.