The Logic Pulse produces on and off logic pulses at user defined intervals. It can be used in two ways. If set to be "normal" then it will pulse on and off at the user defined intervals indefinitely. If set to be "startup" then it will pulse only once on startup i.e. when the device is powered up or when the configuration is loaded. In this condition, at startup, the output of the logic pulse will be off for the "Off time", then on for the "On time" then off again for ever i.e. until the device is rebooted or the config is re-loaded. This is a useful feature if you wish to recall a preset upon startup.
The light on the logic object design block indicates the current state of the output. This is operational in simulation and when online to the device.
Properties
On Time (x 100ms)
Sets the time that the Logic Pulse remains high, in multiples of 100ms, e.g. when set to 10, it will remain high for 1 second.
Off Time (x 100ms)
Sets the time that the Logic Pulse remains low, in multiples of 100ms.
Type
Sets the operation to be "Normal" or "Startup".